Sorry, you need to enable JavaScript to visit this website.

Primary tabs

system wont boot after installation of 1.07

1 post / 0 new
01 Staff's picture
01 Staff (not verified)

Nov 25, 2014 - 11:35am

  • 01 Staff's picture
    01 Staff (not verified)

    I had blank screen issue before I tried to install 1.0.7

    After installing 1.0.7 my system won´t boot at all and is stuck.  Rebooting and setting ¨nomodeset¨ allows me to have functional PC again. Any help is much appreciated:

    Display/graphics were working fine in Windows Vista but NO GO (except for VESA) under Linux Mint

    I also opened a topic on MInt forum for this.

    Desktop with MS-7744 Medion motherboard, Intel 945G graphics
    Linux Mint 17 32-bit mode

    Live USB was already giving me white screen and needed compatibility mode.
    After installation was finished, only blankscreen, needed ¨nomodeset¨ in grub to get display again.

    I noticed the following 2 symptoms:.
    i915 0000:00:02.0: No connectors reported connected with modes

    xrandr didn show anything other then Screen0. No VGA, DVI or whatsoever listed

    I have even upgraded kernel to 3.17-rc2 and even (drm-intel-nighly), unfortunately without any suc6

    I have spent last weekend trying to solve it, but to no avail.
    jaap@jaap ~ $ inxi -Gx
    Graphics: Card: Intel 82945G/GZ Integrated Graphics Controller bus-ID: 00:02.0 1.15.1 driver: intel tty size: 122x32 Advanced Data: N/A out of X

    Any help is much appreciated!!!!

    Nov 25, 2014 - 11:35am
  • fledermaus's picture
    fledermaus (not verified)

    Hm- that all sounds quite messy - I suspect this is not installer related so I'm going to ask the guys who take care of the advanced forum to take a look at your problem.

    Meanwhile, can you grab the output of lspci -vvnn and add it here? Thanks.

    Nov 25, 2014 - 04:29pm